Physics of Paintball :: physics paintball gun

Fuel For A Paintball MarkerThe Reason that people make a tank when they play paintball is because you need a counseling to hurtle the paintballs out of the gun and this can non be achieved effectively by dependable utilize a spring. What they decided to do was to fuel the paintballs by pushing them with a gas. The way in which they did this was to put the gases, either Oxygen, Carbon Dioxide or atomic number 7 under extreme pressure until they squirmed into a liquid and at one time they atomic number 18 in a liquid form they can be blown into a tank which probably looks something like this.Carbon Dioxide must be under a pressure of at least 415.8 kPaA For it to turn into liquid form. Oxygen and Nitrogen ar very similar to this.The way in which the gas is let out is that there is a plague in a valve in the top of the tank and when the tank is screwed into the paintball gull the needle gets pressed down and the entire system becomes pressurized and is ready to be fired. Th en when the gun is cocked and the trigger is pulled the bolt is pushed forward, accelerated by the labour of the C02 acting behind it and pushes the paintball out. Then the bolt comes back into the read grade and the C02 is no longer flowing and is again pushing against the bolt.There are some fusss with this system however. One of the major ones is called gusting, where liquid C02 actually gets into the paintball marker, this is not good for multiple reasons, first of all having the liquid C02 on the miserable parts inside a marker is not good for it, since many another(prenominal) of the parts inside are rubber or plastic. The second problem with this is since the gas is in liquid form it is not expanding as degraded and there for is not pushing the paintballs as effectively. This causes a white snow like substance to come out of the barrel of the marker. There are several way that this problem is dealt with, some markers have the guns stored in a vertical position to keep the liquid in the bottom of the tanks. early(a) markers employ gas lines or expansion chambers, these are basically just tubes or cylinders that run from the tank to the marker and give the C02 a line up to turn from a liquid to a gas.